Wood pellets, Croatia

Wood pellets as climate-neutral fuel

Wood and fibres

Wood pellets are a climate-neutral fuel derived from biomass. Ideally, pellets do not contain chemical binders and have a high energy density. Two kilograms of wood pellets are roughly equivalent to the efficiency of one litre of heating oil. The combustion of wood releases only as much carbon dioxide as the tree absorbed while growing. Pelletising makes the wood more practical for use in private and industrial incinerators; wood pellets are like a bulk material and have good flow properties. The material is also compacted and the pellets have a higher bulk weight than loose wood, which reduces transport volumes. Tietjen’s hammer mills optimally crush wood for the pellet mill.

From tree to pellet

Depending on the pellet quality requirements, the wood must be smaller than 3 to 4 mm before it enters the pellet mill. Of course, it is impossible to obtain this particle size from the entire log in a single step. First, the trunk is debarked and crushed into wood chips by a woodchipper. Because these wood chips are made of fresh wood, they can have humidity levels of 30 to 60%, depending on storage and environmental conditions. However, finished pellets may only have a maximum humidity of 10%, so the material must be dried in any case.

Processing of wet wood

The plant we want to look at more closely produces wood pellets from beech and other hardwoods in Croatia. Here, a belt dryer is used to efficiently dry further crushed material measuring approximately 30 x 10 x 5 mm. Furthermore, the fines content must be very low, as fine particles obstruct the fabric belt of the dryer and lead to dust problems in the exhaust air.

In the Croatian plant, a Tietjen wet wood mill W 1000 performs this task at a capacity of 12 t/h and a humidity of 30-40%. This mill is specially designed for wet and damp wood. The special design of the grinding chamber and housing guarantees the removal of the damp grinding material leading to adhesion.

Fine grinding with the GD 20 large chamber mill

The wood leaves the belt dryer with the final moisture content before finally being ground to the pelletising fineness in a Tietjen GD 20 large chamber mill with a throughput of up to 8 t/h. The GD series is characterised by its generously dimensioned grinding chamber, robust construction and quick change of beaters by a frame system – advantages that also come into play in wood grinding. Moreover, the grinding plant is completely explosion-proof according to the proven Tietjen concept, which is of particular importance for a highly flammable material such as wood.

More sustainability by recycling waste wood

The life cycle assessment of wood pellets can be further improved if residual and waste wood from sawmills, wood-based material production or similar materials are used. Here, too, Tietjen offers a wide range of solutions, such as for crushing wood shavings and sawdust.

All projects

You might also be interested in

More projects
Bananen Bananen
Food

Banana flour for local food production

Uganda is among the world’s poorest countries. Inadequate opportunities to process raw materials leads to post-harvest losses. A local processing centre is now used to turn raw matoke bananas into valuable dry products such as flour, porridge or biscuits.

Gesicht Kind Gesicht Kind
Wood and fibres

Grinding straw to increase regional energy production

In India, large quantities of crop residue are burned in the fields. The Indian government has created incentives to re-process biomass, such as rice straw, into renewable energy sources. Before being pulped, biomass must first be crushed. Tietjen’s hammer mills ensure that straw can be used to produce energy.

Schweine Schweine
Compound feed

Good Feed, Good Food. Hammer mill for manufacturers of compound feed.

Starting in 2020, a GDL 25 will enhance the production of compound feed at a growing feed mill and retail company in Ontario, Canada. It is one of many Tietjen mills running in North America, ensuring a smooth production.